Skip to main content

Latest Post

EEE |1Year-2sem | Basic-Electrical-Engine

  BASIC ELECTRICAL ENGINEERING (Common with Electrical Engineering) Units Overview of DC Circuits DC Circuit Theorems Voltage and Current Sources Electro Magnetic Induction Batteries AC Fundamentals AC Circuits Various Types of Power Plants LIST OF PRACTICALS (To perform minimum six experiments) Operation and use of measuring instruments viz voltmeter, ammeter, CRO, Wattmeter, multi-meter and other accessories Determination of voltage-current relationship in a dc circuit under specific physical conditions and to draw conclusions. Measurement of resistance of an ammeter and a voltmeter Verification of dc circuits: Thevenin’s theorem, Norton’s theorem, Observation of change in resistance of a bulb in hot and cold conditions, using voltmeter and ammeter. Verification of Kirchhoff's Current and Voltage Laws in a dc circuit To find the ratio of inductance of a coil having air-core and iron-core respectively and to observe the effect of introduction of a magnetic core on coil inductance ...
Post a Comment
Read more
Labels

poly 2nd Year, 4th Sem, (EEE) Electrical & Electronics Minor Project Syllabus


Electrical & Electronics Minor Project

General Objectives

After the completing this course the learner will be able to

  1. Become familiar with identification and testing of common tools and components used in electrical and electronics.
  2. Become familiar with domestic and semi-domestic practical models.
  3. Become familiar with preparation of project report consisting of 4 to 5 pages.

Fabrication and testing of the following mini projects.

  1. Single Stage Amplifier
  2. Full wave rectifier using Pi Filter
  3. Two Stage R-C coupled Amplifier
  4. Clipping and Clamped circuit
  5. Porch light using LDR & SCR
  6. Clap Switch
  7. Water Level Indicator
  8. Temperature indicator
  9. Lamp Dimmer
  10. Seven segment display
  11. Fabricate distribution board consisting of 2 or 3 electrical points.
  12. Stair case wiring
  13. 20/40 watt tube light connection diagram

Note:

Student should fabricate and test at least 4 projects and to prepare a small project report for every project consisting of circuit diagram, brief detail of used component and total cost of the project (The report should not exceed from 4 to 5 pages).
Some other mini project can be prepared with the consultation of faculty member according to the local needs / availabilities.


Labels:

Comments

Post a Comment

Popular Posts